Westinghouse GHR795S Manuel d'utilisateur

COOKING GHR16S, GHR16W, GHR17S,GHR17W, GHR765S, GHR775S,GHR95S, GHR95W, GHR795SUSER MANUALGas Cooktops

10GAS CONNECTIONOPERATION ON N.G./S.N.G.GAS CONNECTION CAUTION This appliance is supplied for use with Natural Gas. However, it can be converted for u

11GAS CONNECTIONChecking the gas supply1. Check the manometer zero point is correct.2. Connect the manometer to the cooktop pressure point. This is l

12LPG CONVERSIONInsert oriented for natural gas operationInsert oriented for LPG operationFigure 10TIPS & INFORMATIONRefer to page 13 if you have

LPG CONVERSIONTIPS & INFORMATIONRefer to page 12 if you have been supplied with a DONG YANG regulator.This appliance is supplied set up for Natura

14TESTING APPLIANCE OPERATION2. Observe the flame appearance on each burner. (Figure 12) If it is much larger or much smaller than expected, the inje

15WARRANTY2. Observe the flame appearance on each burner. (Figure 12) If it is much larger or much smaller than expected, the injector size and suppl

AUSTRALIAphone: 1300 363 640fax: 1800 350 067email: [email protected]: www.westinghouse.com.auNEW ZEALANDphone: 09 573 2384fax: 08

2CONTENTSCongratulations and thank you for choosing our Product. We are sure you will find your new cooktop a pleasure to use and a great asset to your

3SAFETYPlease read the user manual carefully and store in a handy place for later reference. TIPS & INFORMATIONImportant – check for any damages o

4INSTALLATION & USEINSTALLATIONCAUTIONYou must read these warnings carefully before installing or using the cooktop. If you need assistance, conta

5CLEANING & CARETo conserve gas, place the pan centrally over the burner and adjust the flame so that it does not extend past the edge of the pan

6TROUBLESHOOTINGTROUBLESHOOTINGFAULT POSSIBLE CAUSES REMEDYBurner will not light even though the sparker is working.• Knob not held down long enough

7INSTALLATION480mm560mm*Gas supply connection location830mmGas supply connection location*480mmFigure 4–60cm and 75cm models cut-outFigure 4–90cm mode

8INSTALLATION1. The bench cutout should be made as per cutout dimensions in Figure 4.2. Adjacent walls, cupboards and protection for combustible m

9INSTALLATIONFigure 7Figure 8–60cm and 75cm clamp locationclamp location Bottom viewclamp locationclamp locationFigure 8–90cm modelspossible clamp loc